1/48 Plastic F-117A Stealth Fighter from Academy Plastics. It's for ages 10 and up. The F-117A is built mostly of aluminum and some titanium. The flat angles, or facets, are designed to reflect radar everywhere except back to the transmitter receiver. The stealth is also covered with Radar Absorbent Material (RAM) to help ward off radar detection. The F-117A is powered by two General Electric F404-GE-F1D2 engines and carries all weaponry internally, the most often used being the GBU-27A Paveway III Bombs. FEATURES: Plastic pieces attached to sprues and molded in black. The surface of the plane is decorated with fully engraved panel lines and sleek anti-radar details. Highly detailed cockpit interior, landing gear, and bomb bay. Flap/aileron assembly is accurately reproduced. Armament includes one GBU-27A Paveway III bomb that fits in the fuselage and attaches to a detailed bomb rack. Clear plastic canopy allows close inspection of cockpit and may be Modeled in an open or closed position. Detailed pictorial instructions guide you through assembly. MARKING OPTIONS: One Decal Sheet with Markings for Two Aircraft: 1: Lockheed F-117A "Toxic Avenger" Col. Al Whitley, 37th TFW 2: Lockheed F-117A; Lt.Col. Ralph Getchell 415th TFS No.790 Airframe Colors: 1: Flat Black 2: Flat Black Detail Colors: Flat White, Silver, Neutral Gray, Olive Drab, Red, Metallic Gray INCLUDES: One 1/48 Plastic F-117A Stealth Fighter REQUIRES: Assembly Cement Paint (see MARKING OPTIONS) Brushes Sprue Cutter Modeling Knife File or Emery Board Scissors Tweezers Water for Decals Glue Tips or Toothpicks Cloth Adult Supervision SPECS: Scale: 1/48 Length: 13-1/4" (33.6cm) (approximately) Width: 10-3/4" (27.2cm) (approximately) Height: 2-1/2" (6.1cm) (approximately)